Its impossible to do with the stock components of your front end (hood, fenders, lights, grill, bumper, etc. You want it to tilt forward like an 18 wheelers nose then you have to make it like the 18 wheelers nose.. a solid front piece with all attached. You dont see just the hood opening up on an 18 wheeler...thats because the whole front clip is one piece. So you would have to either take all of your body panels off.. find a way to fasten them securely together, then custom make brackets to secure the lights to (since in fact the lights are secured to the header panel which is attached to the radiator support) as well as a custom bracket for the grill. OR make a custom front nose so that the hood and fenders rotate seperately from the grill and headlights, around them, so that the lights and grill stay attached to the header/radiator support. OR you can buy the whole fiberglass front cap (one solid piece). But the down side to that is that its meant for race trucks. There are no places for lights. You would still then have to fab up some type of support for lights. The fiberglass cap should be an easier procedure.
As far as bolt on conversion or a company that makes one, to my knowledge doesnt exist because it just isnt cost effective obviously.
|